Base
Measuring for a cut
Cutting with a hand saw
Cutting with a Chop Saw
Making the butt joint for attaching the upright
measuring to place the holes for the screws
drilling countersink holes
gluing the upright
Prepping the base for paint or poly
Rotor
Measuring the wire for the rotor
cutting grooves in the block
cutting the block to size
Drilling the hole in the block
drilling the hole in the dowel
adding a bearing point to the end of the rotor
Electrical
wrapping the wire on the rotor
identifying the ends of the wires
attaching the solar cells
wiring the cells in pairs
wiring the cells to the wrap wire
Assembly
adding the mirror
Adding magnets to the base
Adding magnets to the rotor
Adjusting the magnets for proper alignment
Testing with the light
Troubleshooting the motor
motor does not turn
rotor wobbles too much
rotor climbs the glass
rotor jumps back from the glass
Comments (0)
You don't have permission to comment on this page.